Murphy LS200 Especificaciones

00-02-0671 2014-08-27 Section 15 LS200, LS200N and LS200NDVOR Series Liquid Level Switches Installation and Operations Manual

Section 15 00-02-0671 2014-08-27 - 6 - Installation and Adjustment for Pneumatic Models 1. All pneumatic models operate on the vent principle. T

Section 15 00-02-0671 2014-08-27 - 7 - Replacing and Installing the DVO Assembly NOTE: When replacing/installing the DVO assembly, tubing and fit

Section 15 00-02-0671 2014-08-27 - 8 - Figure 1 - DVO Figure 2 – Adjustable Orifice CAUTION: Ensure that the actuator arm is not bent during re

Section 15 00-02-0671 2014-08-27 - 9 - 14. Connect to the inlet, outlet and exhaust fittings according to installation drawings. Electrical Repl

Section 15 00-02-0671 2014-08-27 - 10 - LS200NDVO and LS200NDVOR 55050621: Regulator only 05706499: 20BPG-D-75 Pressure MURPHYGAGE®

Section 15 00-02-0671 2014-08-27 - 11 - 15051098: External Float Chamber Operating pressure: 2000 psi (13.8 MPa) [138 bar] Operating temperatur

Section 15 00-02-0671 2014-08-27 - 12 - The Murphy Gas Compressor Scrubber Level System (SLS)

Section 15 00-02-0671 2014-08-27 - 13 - Specifications All Models Listed for Class I, Div. 1, Grp. C & D locations Canadian Registration Numbe

NOTES

NOTES

In order to consistently bring you the highest quality, full-featured products, we reserve the right to change our specifications and designs at any t

Table of Contents Product Information ...

(THIS PAGE INTENTIONALLY LEFT BLANK)

Section 15 00-02-0671 2014-08-27 - 1 - Product Information Features Listed for Class I, Div. 1, Grp. C & D locations Canadian Registration Num

Section 15 00-02-0671 2014-08-27 - 2 - LS200NDVOR LS200NDVOR is a float-activated, pneumatic-vent level device used to operate dump valves or simi

Section 15 00-02-0671 2014-08-27 - 3 - LS200NDVO Pneumatic level switch with Dump Valve Operator (DVO) without the pressure regulator for those ap

Section 15 00-02-0671 2014-08-27 - 4 - Pressure Vessel Installation: LS200 and LS200N Direct Installation into the Wall of the Pressure Vessel C

Section 15 00-02-0671 2014-08-27 - 5 - Installation with a Weld Collar 1. The weld collar, P/N 15050375, must be welded into the wall of the pres